ã€China Aluminum Network】Aluminum veneer is a new type of decorative material that has emerged in recent years. It is lightweight, water-resistant, non-vacuum-absorbent, corrosion-resistant, easy to scrub, easy to install, strong in three-dimensional sense, soft in color, nice in appearance, etc. Features, welcomed by users.
Seven processes before arc aluminum coating:
Relying on the previous step, the clean water is used to flush all the dust on the curved aluminum veneer substrate.
In the second step, the arc-shaped aluminum veneer substrate is washed again with alkaline water. Alkaline substances can effectively dissolve the various oils on the arc-shaped aluminum veneer substrate and supplement the stains that can not be removed by the clean water.
The third step is to use clean water to wash out the remaining alkaline material and prepare for the next step.
In the fourth step, the arc-shaped aluminum single-plate substrate was cleaned again with an acidic solution in order to clean the residues on the surface of the curved aluminum single-plate substrate that chemically reacted with the acidic solution.
The fifth step is to clean the curved aluminum veneer substrate again with clean water.
In the sixth step, the arc-shaped aluminum single-plate substrate was chromated, and in the seventh, the chromized arc-shaped aluminum single-plate substrate was cleaned later with clean water.
Punching aluminum veneer punching shape is an important parameter to determine the appearance of the product is beautiful, in general, punching aluminum veneer punching can be designed according to actual needs into a round, square, plum shape and other shapes, net The larger the hole is, the lighter the quality of the aluminum veneer is, but the weaker the pressure resistance and the tensile resistance are, which affects the application site of the punched aluminum veneer. Therefore, the customer must design the size of the mesh according to the actual requirements of the project.
The punching rate of punched aluminum veneer determines the density of the pattern on the aluminum veneer. Too dense punching will cause the pressure resistance of the aluminum veneer to decrease and is not conducive to processing. The punching hole is too unattractive and lacks art. sense. Therefore, punching holes in the punched aluminum slats should be uniform in order to meet the engineering design requirements.
Heavily Hot-Dip Galvanized Wire
Heavily Hot dipped Galvanized Wire
Zinc: 200-350g/m2
T/S: 380-500Mpa
Packing: plastic film inside, hessian woven bag or nylon woven outside
Shen Zhou City Hongda Hardware Products Co.,Ltd is a family owned company, founded in 1998, loacated at Tang feng industry zone, Shen Zhou. It has covered an area of 20 hectares, with a total asset of 20 million and more than 300 people with 80 engineering technicians, a 5-person research group, and a service group dedicated to provide the best solutions.
Heavily Hot-Dip Galvanized Wire,Heavily Galvanized Wire,Heavily Hot Dipped Wire,Woven Mesh Gabions
Shenzhou City Hongda Hardware Products Co.,Ltd , https://www.szhdhardware.com