Look at the contract area to see if the actual equipment is in line with the brand and quantity of equipment and equipment specified on the sales contract. Is it missing? Confirm the drawings and practices in the sales contract are not common, and the structure is not the same as the original design drawing. In the same way, the area of ​​the house is not measured by the real estate department. The area signed with the contract is not different. [Prompt]: Check the sale of the housing contract, usually if the error with the practice measurement area within 3%, will not be considered, the error exceeds 3%, with the compensation contract signed on both sides shall prevail. Advocating an appointment with an area of ​​2% for the area of ​​the house and measuring the actual practice, the best not to exceed 5%. 
The second layer of tape measures the height of the self - provided 5 m tape measure with a 5 m tape measure the height of the building to see if it is in line with the contract. [Prompt]: It is best to keep in a small book, and at the same time write some data and questions about the test house on the paper provided by the property company. 
Check the water to see leaks Bring your own plastic bags, sand, and a plastic washbasin to check the water status: First, use the basin to hold the water, and then fill the water at each of the water outlets. These are the basin water, the bathtub water, the toilet water, the kitchen, and the cleanliness. And the balcony floor drain, etc., is basically every sink should be poured into two pots of water at the mercy of the sound, and no water on the surface. You can also open the faucet, try to make the water flow bigger and anxious, try the water pressure, and try the drainage speed. [prompt]: After doing this, admit that there is no problem, as soon as possible to these outstanding water (such as basin water, bathtub water, toilet water) take a plastic bag cover the nozzle, and then tied, and the floor drain and other water requirements Sesame is used to prevent waste from entering the building and blocking the pipeline. 
The four gongs tapped to listen to the cracks and bring a small gong. They used it to knock on the wall and decorate the floor to check whether the walls and the floor of the house were empty. If you hear the voice of “emptyâ€, it means that there is a gap between the surface and the wall (ground) surface, and the demand is reworked. If you hear the debilitating noise, it indicates that they are touching. [Prompt]: If there is an empty drum, it must be corrected by property personnel as soon as possible. Otherwise, it will be easy to break through the floor in the decoration and hinder the relationship between the neighbors. 
Five walls without dripping cracks carefully check the flatness of the wall to see if there is water seepage and cracks on the wall, especially if there are some water traces on the wall, such as the top surface, exterior wall, etc., if any It is important to find out the reasons as soon as possible. [Tips 1]: The balcony cracks are dangerous. In general, the cracks on the wall are mostly not structural cracks, and they are not dangerous. Problems with the structure of the house often appear on the balcony. If there is a crack in the connection between the room and the balcony, it is likely to be a sign of the breakage of the balcony. The relevant unit must be notified immediately. ã€Tips 2】: If you buy the top floor, be sure to check the top surface of each house for signs of rain leakage. ã€Tips 3】: Pay special attention if there is condensation on the walls in the winter room. There must be a problem with the insulation on the wall. 
The six-door window is flexible and flexible. Try to open doors and windows flexibly. Visually check whether the sides of the door and the door frame, the window and the window frame are parallel, close the doors and windows to hear the sound insulation effect, and also understand the degree of their sealing. Tip: For waterproofing, the bathroom door must be set 1.5 centimeters from the ground. 
The seven pull off the switch to see the branch after the pull off switch to see whether the indoor power is completely off, respectively check whether the various gates fully control the branch lines. It is best to use a multimeter to measure the flow of each strong and weak electricity. [prompt]: Also do not forget to open the telephone, TV line interface, pull a pull, look at the firmness of the socket to see if it is fake. Home inspection experience
Natural rubber, also called India rubber or caoutchouc, as initially produced, consists of polymers of the organic compound isoprene, with minor impurities of other organic compounds, plus water. Malaysia and Indonesia are two of the leading rubber producers. Forms of polyisoprene that are used as natural rubbers are classified as elastomers.
Currently, rubber is harvested mainly in the form of the latex from the rubber tree or others. The latex is a sticky, milky colloid drawn off by making incisions in the bark and collecting the fluid in vessels in a process called "tapping". The latex then is refined into rubber ready for commercial processing. In major areas, latex is allowed to coagulate in the collection cup. The coagulated lumps are collected and processed into dry forms for marketing.
Natural rubber is made of Rubber Plastic Products, which are used extensively in many applications and products, either alone or in combination with other materials. In most of its useful forms, it has a large stretch ratio and high resilience, and is extremely waterproof.
Plastic Screw Cover,Nylon Screw Cover,Rubber Hose,Rubber Pipe
Zhejiang Dream Industry Limited , https://www.mlwdream.com