In order to enhance the overall hardness of the wall of the extruded board, between the two ribs, the inner side of the extruded board is separated by 200mm, and the bonding plaster with a diameter of 50mm and a height of 20mm is adhered at the same time as the adhesive to make the plaster to be bonded. After rapid condensation, it supports the wall between the blasting wall and the extruded board. Paste the extruded board. Start the splicing from the lower corner of the wall (with the door and the window from the door window), and apply the prepared adhesive to the contact surface of the extruded plate and the rib with a flat shovel, about 3mm thick and 4050mm wide, and then immediately The extruded board is installed at a predetermined location, which should be lightly pressed and evenly squeezed, and the extruded adhesive removed. Use the same method to assemble the next plate in turn, and the seam should be as tight as possible. The adhesive should be used with the adjustment and should not be used for longer than the time specified in the product manual.
The construction plan provided by the manufacturer is to be fastened after the entire wall extrusion board is pasted, but it is found that the construction will result in the incomplete bonding between the extruded board and the blasting strip, which will affect the wall plastering process. . To this end, the process is adjusted, and the expansion bolts are fastened after the next extruded plate is installed, so that the extruded plate and the ribs are closely bonded to ensure the overall strength of the inner wall of the outer wall.
Hang the wire mesh. After the wall extruded board is completely finished, the steel mesh can be hung, and the steel mesh is placed on the extruded board and firmly connected with the anchoring head of the expansion bolt (note that the steel mesh should be tightened and fastened from one end in turn). In order to ensure the integrity of the plastering, the mesh and the mesh are overlapped by 100mm. The steel mesh and the extruded surface should have a certain gap, and the position should be in the middle of the bottom ash to prevent cracks in the surface of the extruded board.
Infrared heating is the perfect way to warm a space without the dusty dryness of traditional convection heating. Actually, it offers many advantages to the user: easy to install, fixed direct to the wall or ceiling, reduce your heating costs, CO2 Free, no maintenance and if you are renting, the Panel Heater can be moved easily unlike conventional heaters that are bulky and require professional help. This low-cost heating solution is suitable for wet rooms and bathrooms because the panels is double insulated with an IP rating of 65. The infrared panel reduces condensation and mould in area prone to dampness, which promotes the overall air quality and helps prevent allergies.
Ceiling Mounted Carbon Crystal Heater
Ceiling Mounted Carbon Crystal Heater,Electric Carbon Fiber Heater,Carbon Crystal Wall Heater,Far Infrared Carbon Crystal Heater
Shandong Dexiang Electrical Technology Co.,Ltd , https://www.infraredroomheater.com