Content Tip: The feed test is a relatively inexpensive way to confirm that the mixed product meets the requirements. It is important to note that the ratio between feed consumption and animal weight gain should be considered to determine the input-output ratio and to determine whether performance is desirable.
It is impossible for farmers to buy the best mix ratio feed every time. Sometimes, it is necessary to mix the purchased feed ingredients at a certain ratio. This is why farmers need to know some about how to mix feed ingredients and mix them. Various feed ingredients need to be mixed together to achieve the desired nutritional combination. A typical example is a combination of high-energy feed ingredients (such as ground corn) and high-protein feed ingredients (commonly used for bean cake or cottonseed meal) to obtain a balanced feed of energy and protein balance.
Feed mixing can be simple or complex. Simple blending can be done on a family farm, but complex blends are usually done by commercial feed manufacturers.
Tips for Feed Mixing:
Start an effective formula - study the effective mixing ratio before preparing the feed. Does the formula meet the nutritional needs of the target animal? Is the raw material required for the formulation economical? What is the overhead budget? In most cases, it is best to start with a feed trial. Then develop a based on the test results based on the most economical combination. This results in an economical and efficient mixed feed mix.
Add feed additives as indicated by the label – the cost of mistakes in the process of adding feed additives is often expensive and dangerous. Adding very small amounts of feed additives can often achieve better nutritional results than adding dozens of kilograms of feed ingredients. The type and amount of surface additives must be applied to the surface or label of the feed package so that the feed is only fed to the appropriate animal. It must be borne in mind that some feed additives are beneficial to some special breeds of animals but are harmful to humans.
Weighing of ingredients - bushels or other volume calculations are not reliable compared to weighing.
Mix thoroughly - follow the instructions to check the feed. Feed testing is a relatively inexpensive way to confirm that a mixed product meets demand. It is important to note that the ratio between feed consumption and animal weight gain should be considered to determine the input-output ratio and to determine whether performance is desirable.
Washing machine carbon brushes transfer electricity to the armature of the motor. The armature will then spin and the drum will turn via the drive belt. Washing machine carbon brushes are spring loaded in order that they are always touching the motor armature. Once they are worn to the point where contact is no longer possible the washing machine motor will not turn.
Of course there are other components including electronics that are also responsible for motor rotation but worn carbon brushes are one of the most common reason for your washing machine drum to stop turning and spinning.
If your brushes are worn or damaged when you come to use your washing machine it will fill up with water, appear to sit idle for the duration of the wash and spin cycle (because the drum won't turn), and then drain out the water, and when you open the door of the machine to remove your clothes they will still be soaking wet!
You can find further help and advice here relating to other faults that can cause your washing machine drum to stop turning.
Washing Machine Carbon Brush,Professional Washing Machine Carbon Brush,Washing Machine Motor Carbon Brush,Washing Machine Carbon Brush Motors,Washing Machine Carbon Brush Bushing
Haimen Hailing Carbon Industry Co., Ltd. , http://www.carbonbrush-hl.com