In general, the common word for a screwdriver is a word and a cross. But the screwdriver model is more than these two. But one thing is certain, the screwdriver has no round head because the round head is not twisted at all. The word is to ensure that there is a twist, and the cross can make the power more evenly distributed.
The screwdriver is divided into a manual screwdriver and an electric screwdriver according to the power source. According to the batch head or the cutter head, there is a word (FLATHEAD) and a cross (PHILLIPS). There are many specifications and models. In the industry, it is basically based on the batch. It has two sizes. One is metric, which is what we often say in MM. Let's say those sizes upstairs. There is also an inch system, it is in inches, such as 1/4, 3/16, this number is 25 is the metric size.
1. The model number of the flat-blade screwdriver is expressed as the width of the cutter bar × the cutter bar. For example, 3×75MM means that the cutter head width is 3MM and the rod length is 75MM (not full length).
2. The model of the Phillips screwdriver is expressed as the size of the cutter head × the cutter bar. For example, 2#×75MM means that the cutter head is No. 2 and the metal rod length is 75 mm (not full length). Some manufacturers use PH2 to indicate 2#, which is actually the same. You can roughly estimate the size of the cutter head by the thickness of the cutter bar, but the industry is distinguished by the size of the cutter head. The metal rods corresponding to the models 0#, 1#, 2#, and 3# are approximately 3.0 mm, 5.0 mm, 6.0 mm, and 8.0 mm.
Concerned about surprises
Tag: Model Electric screwdriver Tool head Tool bar Microblogging
Previous: How to extend the service life of wear parts of crushed stone equipment Next: How to solve abnormal noise of motor bearing
Hand Scraped,Solid Oak Flooring ,Fake Wood Flooring ,Laminated Wood
Plastic Floor Co., Ltd. , http://www.nbfloorings.com