We all know that we know that when we install the door at home, we will use the door suction, then what kind of door should we take to remove the door, and what steps are there when the door is removed, and how to install the door. However, we don't know much about these. Next, we will introduce the steps of how to remove the door and how to install the door. I hope everyone can refer to it when installing the door.
1. How to remove the door suction
1. First, use the iron piece attached to the ball lock fitting to remove the grip and insert it into the small hole under the grip.
2. Next, follow the previous steps to easily unscrew the grip. Use a flat-blade screwdriver to pick up the rear gasket, and use a cross screwdriver or electric screwdriver to loosen the set Screw in the ball lock.
3. Also, remove the old ball lock from the other side of the ball lock. However, the lock is removed with an electric screwdriver or a cross screwdriver. Also, a new ball lock assembly grip is removed in the same manner as in step one. Then remove the locking tabs and washers of the ball lock.
4. Then, install the latches first, then load the ball locks and test if the jams between them are exactly bite. Then use an electric screwdriver or screw to attach the locking plate. Then put on the ball lock grip gasket. Press the ball lock grip and press it in.
2. What kind of installation should the door suck?
1. First of all, the construction is prepared, but we must consider whether the door suction is installed on the ground or the wall before installing the door suction. In addition, we usually install the door suction on the wall, but this is not only good to clean but also Will not hinder our walking. Also, when choosing the installation method, then we have to consider the structure of the house, but if there are lockers on the wall, we can consider installing a hidden door stopper on the ground or using an extended door suction.
2. Then go on and determine the position of the door suction, but usually we open the door to the maximum position to determine the position of the door suction, and by opening the door, then fine-tune the position of the door, and until it is found The most suitable place, then open the door to the maximum position again to make the determination. After confirming the position of the door, we can use a pencil to mark the wall.
When we disassemble the door, we don't know what to do. The above article is about how to remove the door and how to install the door. If you want to know more about the decoration, please continue to pay attention. Renovation home network.
More related wonderful reading:
How to remove the door suction method of door suction
How much is the door? How to remove the door suction? What are the door suction materials?
Cross-Recess,Dry Wall Screws,Cross Horn Head Screw,Phosphating Drywall Nail
Handan Changlan fasteners manufacturing ,.Co ltd , https://www.hdchanglanjgj.com