1. Use fluid: air 2. Freezing pressure: 6kg/cm2 3. Maximum working pressure: 7kg/cm2 4, ambient temperature: 0~80 °C 5. Lubricating oil: requires a clean 30′′ engine oil. 6, continuous use: can (but not speed) 7. It is recommended to use the speed: the maximum speed × 0.8 or less. A. If the mixing shaft and the stirring blade of the air motor mixer are different, the original operation will be poor or malfunction. B. The main cause of the failure of the air motor is due to the entry of water vapor or dust. Before the piping, the air must be compressed in the air cleaning tube. Be careful not to let the cutting powder, the broken piece of the sealing tape, dust or rust enter the air pipe. C. The auxiliary machinery of the air motor (air filter, air conditioner, air lubricator, flow valve, etc.) should be installed near the air motor as much as possible. D. The air pressure supply line must be equipped with an air filter, a cold dryer, and an air lubricator. (Lubricating oil should use clean 30′′ oil, 1-2 drops per minute). E. If the air pressure is directly supplied, sometimes the pressure will change and the stable horsepower, torque or number of revolutions will not be obtained, so the air pressure regulator must be used. F. Pipe diameter air pressure machines (air filters, air conditioners, air lubricators, control valves, etc.) must use appliances that meet the air consumption of air motors. G, the control and stability of the air pressure motor speed must be adjusted from the supply air, so exhaust F. Pipe diameter air pressure machines (air filters, air conditioners, air lubricators, control valves, etc.) must use appliances that meet the air consumption of air motors. G. The control and stability of the air pressure motor speed must be adjusted from the supply air so that there is no back pressure on the exhaust side. H. During the test run, use the air control valve to slowly increase the number of rotations to the required number of rotations. The long-time speed operation will also cause damage to the air motor and reduce its service life. Pay attention to the correct use of pressure. Care must be taken during maintenance inspections: A. The air lubricator on the supply air pressure line should also be inspected regularly. If it has been reduced, it must be discarded. |
Rectangle Chafing Dish,Rectangle Chafing Dishes,Rectangle Chafing Dish With Spring Legs,Mobile Table Ware
Shaoxing Biaoyi Hardware Products Co., Ltd. , https://www.byeob.com