The elevator monitoring network bridge installation needs to avoid these pits

Elevator is a complex closed environment, and now mature wireless monitoring has become the choice of elevator monitoring applications. The wireless bridge is a transmission device in wireless monitoring, which is easy to install and low in cost. However, in the actual elevator monitoring installation process, many problems will occur, here are a few points, I hope to help you in the actual installation.

Pit 1: Blind entry?

Elevators are special equipment and have certain risks.

1. Before installation, we need to go to the property to understand the wiring of the elevators and monitors on site.

2. Find the elevator maintenance personnel first, and the external personnel must be led by the elevator maintenance personnel to enter the site (the elevator operators are required to hold the special operation certificate issued by the State Administration of Work Safety in order to take the post).

Pit 2: How to solve the problem of bridge power supply?

Different elevator brands have different structures, and the configurations of the top and bottom of the car are also different. The power of the elevator car roof of the renovation project is very likely to be occupied by the camera. Where does the bridge draw power? During the survey, pay attention to whether the top of the car is a socket. If there is no socket, a separate socket is needed to facilitate the power.

Pit 3: Where is the bridge installed?

When selecting the installation point of the bridge, pay attention to avoiding obstructions as much as possible, especially metal substances will affect the signal. The bridge on the top of the elevator car can be installed on the upper railing; the other one is installed in the foundation pit? It is possible that the foundation pit will accumulate water and affect the signal transmission of the bridge, so it is a better way to fix it on the wall of the elevator shaft.

Pit 4: What fix is ​​used for the bridge?

How to fix the bridge at the top or bottom of the elevator shaft? When the bridge is shipped from the factory, most manufacturers' accessories only contain hoop or cable ties, and there is no bracket, so don't forget to buy the bracket! Hoop and cable ties Hold the bridge tight enough.

Pit five: how to set up a bridge?

Most bridge configuration methods on the market:

1. WEB interface configuration: first enter the two bridge WEB interfaces to set the IP address, then set the transmitter and receiver, and then set the channel.

2. Dial-up bridge: The dial-up key on the bridge, some represent working mode code, grouping pairing code, and IP address code. This can only be achieved if the instruction manual is clearly studied.

3. Digital display bridge: The setting information is presented visually on the bridge, but it still needs to manually set the IP address and channel on the bridge first, and then long press the bridge's dial button to make it paired successfully.

Hikvision's dedicated wireless bridge CP2-300 combines the advantages of dialing and digital display bridges. It only needs one key pairing to set up successfully (one master and one slave, the same channel), visual operation, convenient and fast.

As an important wireless monitoring transmission equipment, the wireless bridge's performance and correct use are related to the normal operation of the entire wireless monitoring system. Therefore, users should learn more about wireless bridge knowledge and choose brand products with reliable quality.