How to paste floor tiles fast and good beginners how to tile

Flooring has always been a crucial procedure in the renovation. However, laying floors is also technical. If they are not properly mastered, they will lose a thousand miles. So, for beginners, how fast and good is it for floor tiles ? In fact, every system project has a masterful plan. Here we take a look at how to shop for beginners!

How to paste floor tiles fast and good - tile soak

For the new tiles, you have to clean it and soak it for two hours. Its main purpose is to allow the tiles to absorb enough moisture, to avoid the water in the material after the paving is removed, resulting in the lack of adhesive water, affecting its firmness, and ultimately leading to hollowing, shedding phenomenon. After the tile has absorbed sufficient water, it is picked up from the water and wiped off the surface moisture, and you're done.

How to paste floor tiles fast and good - set up auxiliary lines

When the tiles have not been tiled yet, the vertical line on the screed is first suspended on the wall. Its main purpose is to determine the line size of the tiles. Then set the horizontal line, because only in this way can we ensure that the tile is laid flat and vertical and the surface is flat. In the issue of how to lay a brick for beginners, this step is also something that we cannot ignore.

How to paste the floor tile fast and good - set support board

When laying tiles, remember to use a horizontal line as a guide to create a board that can support the tiles. The main purpose is to move or drop the house tiles before they reach the adhesion strength.

How to Paste Floor Tiles Fast and Well - Laid Out in Order

Under normal circumstances, the order of paving tiles is: from top to bottom, from left to right. The specific method of paving is: using water to find the leveling layer, and then using a spatula to put the mortar on the opposite side of the tile, and then put the tile on the wall, tap the tile with a shovel or rubber hammer, so that the mud can be Fill the space between the wall and the tiles.

How to paste floor tiles fast and good - cleaning, maintenance

After the local bricks are well-laid, everyone must remember to remove the dust and stains on the surface in time. The specific cleaning method is: If the tile surface is very contaminated, especially stained with hard-to-remove stains, we can use a 10% solution of diluted hydrochloric acid to wipe. However, if you use dilute hydrochloric acid for cleaning, you must remember to clean it with clear water. If it is a glazed diamond, it can be coated with a thin layer of Bailizhu brightener, then wipe it again with a cloth, so that the surface of the tile can be bright and will not be contaminated.

Conclusion of the article: The above article shows you how to paste the floor tiles quickly and well, and how to lay the floor tiles for beginners. I hope to give you some help. In fact, we must remember to clean up after putting tiles on. Because after the cement is hard and clean it has no effect!

Pharmaceutical Intermediates

Pharmaceutical Intermediates,Cytidylic Acid 99%Min,White Powder Alareline Acetate,2-Acetylpyrazine 99%Min

HENAN BON INDUSTRIAL(CHEMICAL) CO.,LTD , https://www.bonchemical.com