ã€China Aluminum Network】 aluminum alloy skirting board is a relatively new type of decorative material, with good decorative, high strength, flexibility, simple and stylish, is a popular decorative material, many people of aluminum Alloy baseboard does not understand, following the aluminum alloy skirting installation methods and precautions for everyone to explain in detail.
Aluminum alloy skirting installation method introduction:
1. Grassroots Treatment Before the installation of the aluminum baseboard, pay attention to the basic processing work. Observe whether the ground and the wall surface are smooth. If there is any unevenness, use a blade to flatten it, clean it, and then install the kick. The foot line, otherwise it will cause the skirting on the installation to be uneven, cannot fit on the wall, there will be ugly gaps, so we must do a good job at the grassroots level.
2, drill holes to be accurate saw a 15-cm long aluminum alloy baseboard, the card snapped in the card slot on the back, against the wall in the buckle hole to mark, and then use a special tool on the wall Drill holes and then use plastic nails to drill into the holes that have just been punched. Care should be taken to secure the snaps to the wall with screws.
3, yin and yang angle treatment of aluminum alloy baseboard in the yin and yang position is very troublesome, the corner of the wall protruding out of the sun is called the angle, the concave corner is called inside corner. When installing the skirting line at the yin and yang corners, pay attention to the position of the fixing point on the wall, then take the hole, nail the plastic nail, and then fix the yin and yang corner with screws on the corner of the wall.
4. After installation, use a tape measure to measure the size of each section. Use a cutting machine to cut out the corresponding size and place it on the corresponding buckle. Each aluminum alloy baseboard has a length of 3 meters. When the length of the baseboard exceeds the length of the skirting board, a snap fastener must be installed at the middle of the interface to ensure the flatness of the baseboard.
Aluminum skirting installation precautions introduction:
1, control the convergence gap Aluminum skirting installation should pay attention to the control and the gap between the floor gap, under normal circumstances the baseboard and the floor convergence of the larger gap can not exceed 3 mm, you can use 1 yuan coins to plug Look, if you can stuff in more than two coins, then it means the gap is too big and you need to reprocess it.
2.Details Handling The details of the installation of aluminum alloy skirtings must not be ignored. Before installation, the wall with white cement must be shoveled clean, and then the baseboard should be paved. After the pavement, it must be completed. Do protective measures to prevent the paint from sticking to the surface of the baseboard due to paint or spray paint. Clean up should be done in a timely manner.
The baseboard of aluminum alloy baseboard and other materials play the same role. It is used to balance the visual aspects of the home, and the walls are to some extent protected from damage. Therefore, the use of aluminum alloy skirting When you are on the line, be sure to pay more attention to these issues and avoid affecting the overall home improvement effect.
Steel Pipe used for conveying fluid pipe, such as oil, natural gas, water, gas, steam, etc.
Steel pipe contains two types: seamless steel pipe and welded steel pipe
Steel pipe is one of our mainly produces ,made of carbon steel, stainless steel, alloy steel and other special metal materials as required by its customers.
Stainless Steel Pipe,Seamless Stainless Steel Pipe,316 Stainless Steel Pipe,Stainless Steel Tube
Shijiazhuang Huize Pipe Fitting Co., Ltd. , https://www.huizegd.com