Washing clothes is of course inseparable from water, so washing machines often have problems with water and drainage. Sometimes it is not enough to enter the water, sometimes it is not water, and so on. For these small problems, if you ask a professional maintenance worker to come to the door to check and repair, it is time consuming and expensive. Here, the author will introduce to you how to eliminate the water in the washing machine and not to enter the water.
1. Into the water more than. In general, the inlet valve spool is stuck. After the power is turned on, it cannot be reset, resulting in water inflow. In this case, the inlet valve should be replaced first. If the fault is not resolved, the problem may be with the water level switch, and the water level switch should be replaced. If the pressure pipe is worn for a long time, the wear is broken or the pressure pipe is in poor contact with the water level switch and the outer nozzle, or the air is leaked, it may cause the water to enter. Because the computer board is not under pressure, the water level switch does not move. The misunderstanding is that the water level is not enough. In this case, check whether the pressure tube is worn or not, and there is no contact or disengagement at the two joints. Due to the long use time, there is a foreign object blocking the mouth of the nozzle, so that the pressure cannot be transmitted to the pressure switch. At this time, the large nut should be unscrewed, and then the inner barrel should be taken out to remove the foreign matter blocking the nozzle. If all of the above operations are invalid, try replacing the computer board, as all actions are controlled by the computer board.
2. Do not enter the water. Turn on the power and listen to the sound of the water valve. If there is, check if the tap water is broken, turn off the faucet, unscrew the inlet pipe joint and check if the filter of the inlet valve is blocked. If there is any plugged out Clean the filter. If the problem has not been solved, replace the inlet valve. The inlet valve spool may not be opened. If the inlet valve does not have a “click†sound, try replacing the computer board. The problem may be on the computer board. (Zhang Peng)
Thermostatic Radiator Valve Head
Thermostatic Radiator Valve Head
Ningbo Safewell Plumbing Co., Ltd. , https://www.safewellbrass.com