Fluorescent lamp mounted with ceiling embedded, suspended and directly mounted
1. The luminaire should be installed indoors and outdoors with good ventilation, less dust, no corrosive gas and combustible and explosive materials. The supply voltage is allowed to fluctuate within the range of +20% to -20% of the rated voltage. Out of range will affect the lighting specifications. Excessive voltage may burn the electronic ballast.
2. Different types of electrodeless fluorescent bulbs can only be used with their matching power electronic ballasts.
3. The cable connecting the bulbs should not be lengthened at will.
4. For the colder winter areas such as the north or places used outdoors, the lamps used should be of high sealing level. It is strictly forbidden to disassemble the used lamp covers.
5. The actual system power deviation of the supporting lamps is within the allowable range within ±10%.
6. When installing fluorescent lamps, you should first read the instructions for the lamps and understand the installation and fixing methods of the lamps, so that the corresponding installation measures can be done in advance.
7. Before installing the luminaire, it is best to connect the luminaire first and then power on to confirm that the luminaire will be on and then install the luminaire. In order to prevent the trouble caused by the transportation or other reasons after the installation, the lamp will not be bright.
8. The width of the upper and lower sides of the steel ring used for the high-hanging lamps (GC series) lampshade is different.
9. When installing, the wide side should be fastened to the side of the light mask, and the narrow side should be used to hold the lamp cover.
1. Correct selection of teeth
1) Before use, confirm whether the mechanical properties of the product meet the customer's requirements (such as the tensile strength of the Bolt and the safe load of the nut).
2) The length of the bolt should be selected properly, with 1-2 pitch exposed after tightening.
3) Before use, the thread should be kept clean.
2. How to use dental strips correctly
1) When tightening the teeth, pay attention to that the direction of force applied by the wrench should coincide with the axis of the screw, and do not tilt.
2) In the process of tightening, the force should not exceed the safety torque, and should be uniform. Try to use the torque wrench or socket.
3) Locking too fast will lead to locking, it is recommended not to use electric or pneumatic wrench.
4) Keep the thread clean. In order to ensure the smooth fit of screw and nut, it is recommended to put the product in a clean container and do not place it at will.
3. Standard of tooth bar maintenance
1) If there is slight damage to the removed tooth, screw and nut, the die and tap shall be used for repair.
2) The removed and repaired teeth, Screws and Nuts shall be maintained by means of oil bubble or lubricating oil, and shall be placed in order according to specifications, models and purposes.
4. Scrap standard
The bolts with obvious crack, broken thread, sliding, disorderly thread, screw tensile deformation, shear trace, etc. which can not be repaired by the on-site leader can be scrapped.
5. Specification parameters of tooth strips
Texture of material:
304/316
Product standard:
DIN975
Surface treatment:
turn into a good guy
Threaded Rods,Full Thread Rod Bolt,Hexagon Socketthread Rod Bolt,Stainless Steel Thread Rod Bolt
Suzhou Gubao Screws Co.,Ltd. , https://www.gbscrewes.com