Detailed discussion on the "classification of joint bearings"

Home>Bearing knowledge>Detailed approach to “classification of joint bearings”
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Detailed discussion on the "classification of joint bearings"

Source: China Bearing Network Time: 2018-01-18
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
The joint bearing is a special type of plain bearing. It is mainly composed of an inner ring with an outer spherical surface and an outer ring with an inner spherical surface; it can accept a large composite; according to its different type and layout; Radial load, axial load or combined load of radial and axial together.
It is usually used for low-speed rocking motion; because the sliding surface is spherical; it can also be tilted within a certain range of viewpoints; the support shaft is not the same as the shaft hole, and the bearing is subjected to the load according to its acceptable capacity. Direction; nominal touch angle and layout; can be divided into radial joint bearings, angular touch joint bearings, thrust joint bearings and rod end joint bearings.
Tianjin Jiayi. Hanging wall 哟ス亟谥岢 Apricot crab governance wall 哟ハ蛐 亟谥岢 亟谥岢 徒 哟ネ 哟ネ 哟ネ 亟谥岢 亟谥岢 街 街 郑 郑 郑 郑 郑 唤 唤 唤 唤 唤 唤 唤 唤 唤 唤 唤0 but less than 30; the combined load that is accustomed to accept the axial load of the radial load together; the angular touch thrust joint bearing has a nominal touch angle greater than 30 and less than 90. Suitable for receiving axial loads; can also accept combined loads; but at this moment its radial load should not be greater than 0.5 times the axial load.
Tianjin Jiayi. and Pingshuo are more suitable for receiving axial loads; they are not suitable for radial loads; rod end joint bearings are suitable for axial loads with small radial loads.
The joint bearing belongs to the sliding bearing; it is suitable for the active self-aligning bearing; it is suitable for the low-speed heavy-duty occasion of active centering; although it is widely used in the field of use; it can be used narrowly; the joint bearing used on the motor is mainly the radial bearing; Such as wind power brackets.
Recommend to friends comments close window

Bearing related knowledge
Bearing CAD drawing software clarifies that å•¥ is a foil bearing?
Technical standard pre-loading precautions for overhauling centrifugal pump bearings
The reason for the early failure of SKF bearings


This article links to http://
Please indicate the bearing network http://

Previous:Description and Features of Four-Point Touch Ball Bearings Next: Linear Bearing Features

Bathroom Grab Bar

Bathroom Grab Bar,Hinged Grab Bar,Disabled Grab Bar,Bathroom Safe Grab Bar

NINGBO AIKEHAN METAL PRODUCT CO.,LTD , http://www.diecastingsupplier.com